SSH Tectia  
Previous Next Up [Contents] [Index]

    About This Document >>
    Installing SSH Tectia Server for IBM z/OS >>
    Getting Started with SSH Tectia Server for IBM z/OS >>
        Running the Server
        Environment Variables for Server and Client Applications
        Running Client Programs>>
    Setting up Non-Interactive Server and User Authentication >>
    Setting up Non-Interactive Secure File Transfer >>

Environment Variables for Server and Client Applications

The environment variables _CEE_RUNOPTS, _BPXK_AUTOCVT, _BPX_SHAREAS, _BPX_BATCH_UMASK and LIBPATH must be set as shown in SSHENV and sshsetenv when running SSH Tectia Server for IBM z/OS programs (see below). The server startup procedures described in Section Running the Server set these variables automatically for the server.

The NAME=VALUE format (as in SSHENV) is used when the client or server programs are run under MVS, and the Bourne shell format (as in sshsetenv) is used when the programs are run from a USS command line.

Note: The environment files must not contain line numbers or reading them will fail.

SSHENV:

_CEE_RUNOPTS=FILETAG(AUTOCVT,NOAUTOTAG),TRAP(ON)
_BPXK_AUTOCVT=ON
_BPX_SHAREAS=NO
_BPX_BATCH_UMASK=0022
LIBPATH=/opt/tectia/lib:$LIBPATH
SSH_DEBUG_FMT="%W(72)(2) %Dd/%Dt/%Dy %Dh:%Dm:%Ds:%Df %m/%s:%n:%f %M"

sshsetenv:

_CEE_RUNOPTS="FILETAG(AUTOCVT,NOAUTOTAG),TRAP(ON)"
export _CEE_RUNOPTS
_BPXK_AUTOCVT=ON
export _BPXK_AUTOCVT
_BPX_BATCH_UMASK=0022
export _BPX_BATCH_UMASK
_BPX_SHAREAS=NO
export _BPX_SHAREAS
LIBPATH=/opt/tectia/lib:$LIBPATH
export LIBPATH
SSH_DEBUG_FMT="%W(72)(2) %Dd/%Dt/%Dy %Dh:%Dm:%Ds:%Df %m/%s:%n:%f %M"
export SSH_DEBUG_FMT

Previous Next Up [Contents] [Index]


[ Contact Information | Support | Feedback | SSH Home Page | SSH Products ]

Copyright © 2011 SSH Communications Security Corp.
This software is protected by international copyright laws. All rights reserved.
Copyright Notice