SSH Tectia  
Previous Next Up [Contents] [Index]

    About This Document >>
    Installing SSH Tectia Server for IBM z/OS >>
        Preparing for Installation >>
        Upgrading Previously Installed Secure Shell Software >>
        Installing the SSH Tectia Server for IBM z/OS Software
            Unpacking the Installation Package
            Creating the SAMPLIB and PARMLIB Datasets
            Preparing the System
            Creating the SSHD2 User
            Creating the /opt/tectia Directory
            Running the Setup Script
    Getting Started with SSH Tectia Server for IBM z/OS >>
    Setting up Non-Interactive Server and User Authentication >>
    Setting up Non-Interactive Secure File Transfer >>

Installing the SSH Tectia Server for IBM z/OS Software

SSH Tectia Server for IBM z/OS is installed to the USS area using an appropriate USS shell, for example an OMVS shell or a Telnet session.

The installation consists of the following steps:

  1. Unpack the installation package. See Section Unpacking.
  2. Create the SAMPLIB and PARMLIB datasets. See Section Creating SAMPLIB.
  3. Prepare the system. See Section Preparing.
  4. Create the SSHD2 user. See Section Creating SSHD2.
  5. Create the /opt/tectia directory and a mount point for it. See Section Creating /opt/tectia.
  6. Run the setup script. See Section Running Setup.

Unpacking the Installation Package

Creating the SAMPLIB and PARMLIB Datasets

Preparing the System

Creating the SSHD2 User

Creating the /opt/tectia Directory

Running the Setup Script

Previous Next Up [Contents] [Index]


[ Contact Information | Support | Feedback | SSH Home Page | SSH Products ]

Copyright © 2011 SSH Communications Security Corp.
This software is protected by international copyright laws. All rights reserved.
Copyright Notice