The print settings can be configured using the Printing page of the Settings dialog.
Select the Font Name and Font Size to be used in the printed output. Any non-proportional font installed on your system can be selected.
Select the width of the blank border around the page in printed output. The margins for the top, bottom, left and right side of the page can all be specified individually. The default value for all margins is 10 millimeters (or 1 centimeter).
Select additional information to appear on the printed pages.
Title appears at the top left of the page and displays the
title of the terminal window (for example
remotehost - Tectia Client).
Date appears at the top right of the page and displays the date
and time when the page was printed (for example
15 September 2003,
11:10). The date and time format is the same as used in Windows.
Page number appears at the bottom right of the page (for
Page 1 of 2).
Pass-through printing allows the server to print on a client printer using terminal emulation codes.
In raw mode, Tectia Client sends the data to be printed as plaintext to the printer. In this mode, printing for example line graphics does not work.
If not in raw mode, Tectia Client sends the data to be printed to the printer as graphics. This is the default setting and should be used if there are no problems in printing. However, some older printers might not support printing graphics.
Select this check box to pass the data to be printed to the printer in raw mode. If you experience printing problems, select or clear this selection as applicable.